DRIVETRAIN C549 6 5. Push clutch fluid pipe forward to seat properly and press the clip down till the clip to completely arrest the connector; refit the cap on the bleed valve. 6. Top up the recommended brake oil to the Max. Mark. CLUTCH SLAVE CYLINDER BLEEDING PROCEDURE (TYPE – II) NOTE: Two technicians are required for this process, one to be seated on the driver seat. Ensure that the brake fluid in the reservoir is filled little above the max. mark. 1. Position the vehicle on a two- post lift and raise it to a height, where it is convenient to the technician to access the clutch slave cylinder. 2. Remove the bleed plug cap on the bleed port on the clutch slave cylinder body. 3. Connect the bleed pipe (1), press the clip (2)down and pull out the clutch fluid pipe (3),(keeping the clip pressed down) till it is stopped by the pressed clip. 4. With the pipe in that position pump the clutch pedal till the air bubbles stop completely and only brake fluid comes out of the bleed pipe. 5. After the bleeding is done, push the clutch fluid pipe inwards to seat properly. NOTE: - The clip automatically comes back to its earlier lock position when pipe is pushed forward. 6. Remove the bleed pipe and refit the cap on the bleed port. 7. Top up the recommended brake oil to the Max. mark.
RkJQdWJsaXNoZXIy MTIwNTUz