ENGINE 1.3L QUADRAJET (90PS) 83 WARNING : Unless replacement is necessary, Suction unit, fuel level sensor should not be removed from the tank since the rubber parts i.e. gasket, seals etc. may get exposed to air, light and may become hard. Never apply an excessive force to the suction unit nipple or lead wire. This may result in bent or poor contact. ASSEMBLY : Assemble the Suction unit in reverse order of removal as explained above. INSPECTION : 1. Use an ohmmeter to confirm that the resistance of the fuel level sensor changes with the level of float position. ACTION REASON DO NOT : Drop fuel module /Level sensor on floor Could cause damage to internal components (Float, Float Arm, TFR) DO NOT : Use level sensor harness for hold / carry Wiring harness damage/ disconnection can happen fuel level sensor DO : Handle the level sensor carefully Not damage the TFR, Float Arm DO : Ensure that the hoses are routed properly and Improper routing, kinks and fouling of hoses with other there are no kinks/rubbing with other components components causes hose damage DO : return any dropped, damaged defective or Ensure fast and correct diagnosis of root cause. suspect material with a tag that describes the problem DO NOT : Disassemble fuel level sensor assembly Warranty void internal parts.
RkJQdWJsaXNoZXIy MTIwNTUz