ENGINE 1.3L QUADRAJET (90PS) 57 8. Check that the axial clearance between the pump cover support plane and the top of the gears is within the recommended values of 0.025mm ~ 0.075mm; if this is not the case, replace the oil pump assembly. End float between the pump casing support plane and the 0.025 ~ 0.075 top of the gears (mm) 9. Check that the height of the oil pressure relief valve spring is within the recommended value of 36mm (with a test load as given below); if not, replace the spring. Height of engine oil pressure relief valve spring with test load of 36.0 5.44-6.02 daN (mm) 10.Fit the crankshaft front oil seal (1a) using the tool 287158900629 (Fitting Tool) (1b). 11.Place the driven gear in position. 12.Place the drive gear in position. 13.Fit the oil pump cover in its housing and tighten the bolts. 14.Position the intake duct complete with gasket in its housing and secure it using the bolts. 15.Place the oil pressure relief valve in position and tighten the cap. NOTE : Manually rotate the gears to check that they turn without sticking. 16.Drill and remove the water/oil sealing plugs from the crankcase to allow for washing the ducts.
RkJQdWJsaXNoZXIy MTIwNTUz