ENGINE 1.3L QUADRAJET (90PS) 53 19.Remove the bolts (1a) and remove the connecting rod caps (1b). 20.Remove the lower crankpin half-bearings. 21.Remove the connecting rod - piston assemblies. 22.Remove the upper connecting rod half-bearings (4). 24.Remove the crankshaft (1a) complete with rear oil seal (1b). 25.Remove the upper main journal half-bearings. NOTE The central main bearing half is joined to the thrust half-rings. Press the ends of the halfbearing to separate. 23.Check that the crankshaft end float corresponds to the recommended figures of 0.055 ~ 0.265 using a magnetic base and dial gauge (1). NOTE : If the value for the crankshaft end float does not correspond with the recommended figures, use suitable oversize thrust washers.
RkJQdWJsaXNoZXIy MTIwNTUz