ELECTRICAL 74 12.19 SEAT BELT REMINDER SYSTEM To enhance the safety level of all occupants, vehicle is equipped with seat belt reminder system. The sys- tem has visual and audio warnings to remind the oc- cupant to fasten the seat belts. Indication for driver is located in the instrument cluster. Indications for other passengers are located on the facia panel. Above features work in conjunction with Body Control Module. Components: Seat Belt reminder controller Seat belt switches for co-driver and rear passengers (3 nos.) Co-driver seat occupancy sensor. 4 LEDs for indication mounted on near Facia switch panel Related electric wiring harness Operation: For driver and co-driver (if co-driver seat is occupied), if seat belts are not fastened and ignition is turned on then buzzer will be on and correspond- ing indications will flash. Buzzer will stop working after 5 seconds and indications will continue to work. Once vehicle crosses 10 kmph in forward direction then buzzer will come on for 120 seconds, indication will continue to flash. Within 120 seconds of operation if vehicle speed goes below 10 kmph or reverse gear is engaged, then buzzer and indications will stop working and will start a fresh cycle of 120 seconds when for- ward speed of 10kmph is achieved. After 120 seconds both buzzer and indication will stop working and will not come on in the same ignition cycle. Buzzer and indication will stop working as soon as seat belt is fastened. If rear passenger seats are not occupied or rear passenger seat belts are not fastened, indications will come on after achieving 10 kmph speed in for- ward direction and will continue to work for 120 seconds. After 120 seconds indication will stop working. If vehicle speed goes below 10 kmph or reverse gear is engaged then indication will stop and will resume after 10 kmph speed is achieved in for- ward direction. If rear seat belts are unfastened (which were fastened earlier) and vehicle speed is more than 10 kmph then buzzer will come on for 5 seconds and indication for 120 second for that corresponding rear seat. After 120 seconds indication will stop working. SEAT BELT REMINDERCONTROLLER Location: Seat belt reminder controller is located behind the glove box. Specification: Normal voltage: 12V DC Operating voltage range: 9V to 16V Operating temperature: -20°C to +60°C Current drawn: When powered and no output is ON less than 5mA
RkJQdWJsaXNoZXIy MTIwNTUz