SUSPENSION 39 10. REAR BRAKE DRUM BEARING FITMENT Insert the new bearing to the brake drum using the bearing installer special tool part no (2871 5890 4202) as shown in the Figure. 10a fit the circlip 11. Detach the hand brake cable from the lever on the trailing shoe by moving the lever towards the centre of the brake and removing the cable nipple from its location in the end of the lever as shown in Figure. 12.Remove the hand brake cable holder lock pin from the back plate 13.Remove the rear sensor cable mountings on the twist beam axle 14.Disconnect the brake lines mounting on the twist beam as shown in Fig. 15.Disconnect the bundy pipe/Hose from wheel cylinder. Remove bleed screw. Put rubber dust cap on to the bundy pipe to avoid brake fluid from spilling and contamination.
RkJQdWJsaXNoZXIy MTIwNTUz