TURNING NOISE REPAIR (1.5CRAIL) 1 1. TURNING NOISE REPAIR (1.5CRAIL) PROCEDURE NOTE This procedure is to be done whenever following aggregates are dismantle from vehicle. 1. ENGINE 2. TRANSMISSION 3. DRIVE SHAFT (BOTH) 4. INTERMIDDIATE SHAFT Open the Bonnet & Measure distance ‘d’. If ‘d’ is between (23 - 25.3mm) then there is no any issue, If it is less than 23mm then follow the steps given in following procedure. Check the distance ‘d’ as shown if noise is heard while turning. PROCEDURE A. Disconnect the electrical connection of battery, loosen the mounting of battery & take out the battery. B. Loosen & remove the battery tray for the visibility of B-mount. C. Take vehicle on two poster & loose the nut of both RH and LH side stopper bracket (Sway arrestor). D. Support the transmission from bottom side with jack.
RkJQdWJsaXNoZXIy MTIwNTUz