TA6300 AMT KIT 15 10 CLUTCH POSITION SENSOR REMOVAL AND RE-FITMENT ON BENCH:- Removal: 1. Disconnect the connector of the wiring harness from the ‘Clutch Position Sensor’. 2. Unscrew and remove the two screws fixing the ‘Clutch Position Sensor’ on the ‘Power Unit Base Plate’ body. Installation: 1. Position the spare part ‘Clutch Position Sensor’ on its seat using the two spare parts screws of fixing for reference. 2. Screw the two spare parts screws at the right torque 2.5 ± 0.1 Nm. 3. Connect the connector of the wiring harness on the ‘Clutch Position Sensor’. 11 HYDRAULIC OIL ACCUMLATOR REMOVAL AND RE-FITMENT ON BENCH:- DANGER!! Do not remove hydraulic oil accumulator, it is pressurized unit it can pose a safety threat. 12 POWER UNIT (PWU) BASE PLATE REMOVAL AND RE-FITMENT ON BENCH:- Removal: CAUTION Ensure there is “NO PRESSURE” in the hydraulic circuit. 1. Disconnect all the connectors of the system wiring harness (DC Motor, Cultch Position Sensor and Transmission Control Unit) and remove the ‘Plastic Clip’ pulling it out from its threaded hole on the ‘Power Unit Base Plate’ body. 2. Remove the ‘Mechatronic Gear Actuator’ unit (MGA) first (refer the procedure 7. Mechatronic Gear Actuator Unit (MGA) Removal and Re-Fitment on Bench).
RkJQdWJsaXNoZXIy MTIwNTUz