DRIVESHAFT 10 6. ON VEHICLE PROCEDURE A. DRIVE SHAFT (LH / RH) REMOVAL 1. Lift the vehicle on using two post lift and remove the front wheels. 2. Drain the Transaxle oil through Drain Plug. 3. Remove wheel nut & take out wheel. 4. Remove ball joint (steering rack) from steering knuckle from RH & LH sides using tool part no. 2702 5890 4602.(Refer Steering Section) 5. Remove stub axle ball joint Mtg. & Remove Lower Control Arm (LCA) using tool part no. 2702 5890 4602.(Refer suspension section) 6. Swing out drive shafts from transaxle and place it suitably alongside. Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. FITMENT For fitment, follow reverse procedure of removal.
RkJQdWJsaXNoZXIy MTIwNTUz