TRANSAXLE TA6300 39 26. Remove Outer race cylindrical roller bearing of lay shaft from front housing with the help of puller 5438 5980 2603. 27. Remove Outer race cylindrical roller bearing of Input shaft from front housing with the help of puller 5438 5980 2603. NOTE: SHIMS SHOULD NOT BE REUSED. NOTE: 1. Apply anabond 112 on threads of all fasteners 2. Apply silicon liquid gasket anabond 690 on housing interface. 3. The chips collected by magnetic drain plug, are to be removed at the time of every oil change. 4. Keep inner and outer races of taper roller bearing in sets. 5. Use sealing anaerobic compound for all oil seals outer diameter. 6. For oil seals of input drive shaft and bellows use anabond 112. INPUT SHAFT DISASSEMBLY 1. Fix input shaft assembly on vice with adaptor bush. & remove Locking Screw. 2. Install support plate 5438 5890 2602. 3. Place input shaft assembly on hydraulic press with support plate & press input shaft as shown. Hold input shaft from bottom. 4. Take out 6th 5th gear, gear bushes, synchro cones, needle cage, shifter sleeve & support plate separated from input shaft from press.
RkJQdWJsaXNoZXIy MTIwNTUz