TRANSAXLE TA6300 34 21. Remove Drive shaft from co-driver side. Note: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 22. Remove heat shield of starter motor as shown. 23. Remove electrical connection & its three mountings from starter motor & take out the same. 24. Remove C-Bracket mountings from Subframe assembly & Gear box also take out C-mounting bracket. 25. Remove Sub-Frame Assembly with lower arm as shown 26. Give push support from bottom side of Engine Assembly.
RkJQdWJsaXNoZXIy MTIwNTUz