TRANSAXLE TA6300 24 1.9. REMOVAL OF TRANSAXLE FROM VEHICLE: Position the vehicle properly on the two-post lift and loosen the front wheel nuts. Disconnect the battery terminals. 1. Remove the battery connection and remove the battery & tray. 2. Lift the vehicle on using two-post lift and remove the front wheels. 3. Drain the Transaxle oil through Drain Plug. 4. Remove the air filter assembly. 5. Disconnect power steering pressure line and its mounting over transaxle. 6. Remove ball joint (steering rack) from steering knuckle from both sides. 7. Disconnect gear shifter cables. 8. Loosen mounting bolts of clutch housing. 9. Remove the cooling module of the vehicle (Refer Remove and Re-fitment of cooling module in engine). 10. Remove fuel line supporting bracket from clutch housing. 11. Disconnect high-pressure hose assy. from clutch release lever. 12. Support engine suitably using engine lifting crane. 13. Disconnect ‘C’ mount bracket bolt. 14. Disconnect the starter motor electrical connection & take out Starter motor 15. Disconnect electrical connections of Reverse Light switch. 16. Disconnect the knuckle lower arm ball joint. 17. Swing out both drive shafts from transaxle and place it suitably alongside. Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 18. Lift and support the engine assembly suitably on vehicle. 19. Loosen and remove B Mount Bracket. With rubber pad. 20. Remove clutch housing mounting bolts and take out the transaxle.
RkJQdWJsaXNoZXIy MTIwNTUz