CLUTCH 18 Do not use any screw driver or other type of steel material to rewind the adjuster ring. You might damage the mechanism. In any of the cases do not deform the dead stop ring. When SAC or disc fell down on the floor do not use it again. Pay attention to "GEAR BOX SIDE" mark to ensure correct assembly of clutch disc Do not assemble an used SAC together with a new disc or vice versa. FITMENT For fitment follow the reverse order of the removal procedure, using the Clutch Mandrel. However, following care must be taken during installation. Clean friction face of flywheel by dry clean cotton and check for cracks, scoring, burn marks or unevenness. If there are any defects replace he flywheel. NOTE Do not machine the flywheel. Install SAC assembly (Before installation ensures that the disc face stamped with ‘Gear Box side’ mates the pressure plate face). Press aligning mandrel through the SAC assembly on flywheel by locating the front end of the mandrel in crankshaft. Ensure correct flywheel side & pressure plate side of clutch disc.
RkJQdWJsaXNoZXIy MTIwNTUz