1.5L REVOTORQ ENGINE 109 10.Insert rear assy. pipe In middle pipe up to stopper touch to rear pipe and just hand tighten the nut. 11.Tighten the front pipe and middle pipe flange nut by pneumatic tool & apply tightening torque-2.3 kgf.m. 12.Tight the pipe in pipe joint clamp nut by pneumatic tool & apply tightening torque 3.5 kgf.m. NOTE Ensure flex bellow should not be pre stress or bend as shown in below figure & also ensure proper orientation of rubber hangers D. COOLING SYSTEM ON VEHICLE REPAIRS A. INTERCOOLER REMOVAL 1. Remove the front bumper. (Refer front bumper removal procedure from Body section). 2. Loosen spring clamp and disconnect the intercooler inlet and outlet hoses. 3. Loosen and remove the 2 bolts and take out the intercooler assembly. FITMENT For fitment follow reverse procedure for removal.
RkJQdWJsaXNoZXIy MTIwNTUz