TA65 Star AMT 42 12. ASSEMBLIES OF TRANSAXLE: 1. Fit clutch release fork shaft. Fit plastic bushes. Fit lever on clutch release shaft and lock it by grooved pin. 2. Differential bearing preload adjustment procedure. Measure dimension ‘A’ (Distance between top mating surface of transaxle front half and the outer differential bearing seat) say 103.7mm in housing and dimension ‘B’ (Distance between mating surface of transaxle rear half and the inner differential bearing seat) say 19mm in housing for bore 65.088 mm dia. Place outer races on both differential side bearings and measure distance between outer surfaces of these outer races (dimension ‘C’). Select shim thickness = (A+B) - C to (A+B) - C+ 0.05 and install the shims against front half taper roller bearing outer race. 3. Fix the outer race of differential bearing in the housing (front half) by using drift part no. 2654 5890 3507. 4. Remove sensing wheel using by puller part no. 2651 5890 3506 and rest pad part no. 2702 58902612N. 5. Place the assembly differential in front half housing.
RkJQdWJsaXNoZXIy MTIwNTUz