TIAGO/TIGOR AMT Gasoline DTC Troubleshooting Guide Version: 4.0 Date: 18-04-2017 Author: Sathi/Anupama Page: 237 of 427 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. DTC P0710-02), are sensor connections OK? operation (refer DTC P0710-04). 6 Clear the DTC and drive the vehicle through all gears for 10 kms. Key OFF, repeat this cycle 5 times. Is the fault recurring? Replace clutch Release vehicle to the customer after final drive test DTC’s confirmation:- After rectification, clear all DTC’s and ensure the following points by referring TCU parameters using TML diagnostic tool before handing over to customer. Pickup the vehicle to 20 Kmph under heavy throttle (>50%), and decelerate to standstill, do this for 10 cycles and monitor the clutch temperature and ensure it is less than xyz. Drive the vehicle through all gears in both Automatic and Manual modes Ensure no DTC is active and Transmission Fault Lamp is OFF. Circuit Schematic Diagram:
RkJQdWJsaXNoZXIy MTIwNTUz