ELECTRICAL 60 COMBI STALK REPLACEMENT PROCEDURE 1. Remove the combi switch from vehicle. Refer removal & refitment of steering nacelle from steering section. 2. Disconnect combi switch connection. 3. Remove the two mounting screw of the stalks as shown below 4. Remove the stalk. INSTALLATION: 1. Fit the new stalk. 2. Tight the mounting screws of stalk. 3. Fit the combi switch. INSTALLATION 1. Fit the new stalk 2. Tight the mounting screw of stalk 3. Fit the combi switch Torque value Table Component Tightening torque value Light / Wiper Stalk tightening torue in Daesung make combi Switch 0.3 to 0.4 Nm Clock spring 6 to 8 kgf-cm
RkJQdWJsaXNoZXIy MTIwNTUz