STEERING 13 3. Turn off the IGN switch and wait for 20 sec or more. Then do regular check after starting the engine. Tightening torque value is 18-22 Nm. Erase the DTC if available. NOTE: Do not open the servo unit for any repair because it is precisely calibrated. 2.3.5 MOTOR REMOVAL 1. Disconnect battery. (Refer battery removal procedure/Body Electrical group). 2. Remove steering wheel (Refer Steering wheel removal procedure). 3. Remove two screws and one nut of cover nacelle. 4. Remove lower panel covers attached to the dashboard. 5. Disconnect the multifunction switch connector. 6. Remove the column outside. 7. Remove the mounting bolt and remove motor.. REFITMENT: 1. Conduct the “Calibration” and “ECU” variant (Petrol or Diesel “ by TATA tool. 2. Erase the DTC if available. 3. Turn off the IGN switch and wait for 20 sec or more. Then do regular check after starting the engine. Tightening torque value is 18-22 Nm.
RkJQdWJsaXNoZXIy MTIwNTUz