STEERING 20 Wheel Lock Angle Wheel lock angle (Outer) 31.96° Wheel lock angle (Inner) 36.59° NOTE: a) Please follow manufacturer’s (of tire replacement machine) manual for wheel alignment instructions, recommendations and any other additional information. b) Camber & TOE-OUT value at front has to be adjusted while doing wheel alignment. Rest of the values remains fixed i.e. NO adjustments are required. Refer the given table for standard values. CAMBER ADJUSTMENT 1. Loosen the two strut mounting bolts. 2. Rotate the eccentric pin on Top of the strut till required camber value is achieved. If not check eccentric pin for excessive wear. If so, replace with new one. 3. First tighten the eccentric pin flanged nut to specified torque & then tighten the bottom bolt to specified torque. TOE OUT ADJUSTMENT 1. Loosen the tie rod end check nuts. 2. Steering rack & pinion gear comes with 1270.2±3 mm (nominal) length between centers of the ball joints with tie rods parallel to the rack. (As shown in following figure) Ensure that number of threads of outer ball joints exposed out of the tie rod tube is same on LH and RH side. 3. Rotate the steering wheel from lock to lock. Measure the number of turns. 4. Bring the steering gear to centre by rotating through half the number of measured turns. 5. Remove the steering wheel & refit it so that spokes & mascot (T-emblem) are correctly positioned. 6. Ensure that both front tires are in straight ahead position. Tighten the steering wheel nut to specified torque. 7. Adjust toe-out as given below. a) Toe-out is adjusted by varying the length of tie rods after loosening their lock nuts (as shown in above figure). After adjusting the length of tie rods recheck toe-in and tighten back the lock nuts. Increasing length of tie rod will reduce the toe-out and vice-versa. b) While adjusting toe-out, adjust the length of both tie rods by rotating them in the same direction such that their lengths remain equal at all times. 8. Check the position of the T-emblem and the spokes if the steering wheel is not centered,
RkJQdWJsaXNoZXIy MTIwNTUz