BRAKES 54 2. Remove Wiper cap from Isolator tub, and apply grease inside wiper cap. 3. After applying grease, place wiper cap again on isolator tub. 4. Operate Parking brake lever 3~4 times for smooth functioning. 5. Replace Bottle Holder on center console located in the cabin back to its position. 13.9. REMOVAL AND REFITMENT OF ABS ECU / HCU Following precautions should be carried while working on ABS. 1) Before undertaking any electric arc welding work, disconnect the ABS ECU’s connector. 2) During paintwork operations or major repair work, which are likely to subjected to higher temperature (above 85° C), The HCU must be removed. 3) Before removing the ECU, the battery must be disconnected. 4) Terminals must be fully tightened while installing battery. 5) Electrical wiring not to be repaired (should be replaced) REMOVAL 1) Turn OFF the ignition switch and disconnect battery. 2) Disconnect ABS ECU wiring harness connector. NOTE: Refer steps (i) and (ii) to disconnect ABS ECU Connector. (i) Press the unlock button and remove the lever from the lock and move towards unlocking position. (ii) Lock the lever to its unlock position by pressing the lever till the Click sound is heard and remove the connector from ABS ECU. WARNING: Never apply a 12V power source to any terminal of the ECU connector when it’s disconnected. 3) Identify the brake pipes going into and out of the Hydraulic Control Unit (HCU) with tags so that reinstallation of the brake lines becomes easy.
RkJQdWJsaXNoZXIy MTIwNTUz