DRIVETRAIN-TA65 Star 63 10. Fix sensing wheel with recess inside using drift part No. 2654 5890 3507. 11. Press taper roller bearings using drift part no. 2702 5890 2608 on either side of differential housing. R. ASSEMBLIES OF TRANSAXLE: 1. Fit clutch release fork shaft. Fit plastic bushes. Fit lever on clutch release shaft and lock it by grooved pin. 2. Differential bearing preload adjustment procedure. Measure dimension ‘A’ (Distance between top mating surface of transaxle front half and the outer differential bearing seat) say 103.7mm in housing and dimension ‘B’ (Distance between mating surface of transaxle rear half and the inner differential bearing seat) say 19mm in housing for bore 65.088 mm dia. Place outer races on both differential side bearings and measure distance between outer surfaces of these outer races (dimension ‘C’). Select shim thickness = (A+B) - C to (A+B) - C+ 0.05 and install the shims against front half taper roller bearing outer race. 3. Fix the outer race of differential bearing in the housing (front half) by using drift part no. 2654
RkJQdWJsaXNoZXIy MTIwNTUz