TIGOR EV SERVICE MANUAL

BRAKES 58 16.7. REMOVAL AND INSTALLATION OF PARKING BRAKE CABLE 1. Remove the brake drum - refer Removal brake drum. 2. Remove the parking brake clip from the rear brake assembly. 3. Disconnect the parking brake cable from the shoe lever - refer Brake shoe removal. 4. Remove the cable from the rear brake assembly. 5. From the cabin, remove the Rear Cup holder. Loosen the parking brake slackness adjustment nut located inside the console that can be accessed through the Cup holder opening. 6. Remove the parking brake cable that is snap fitted to the cable-mounting bracket located underbody. 7. Remove the Primary cable of the Parking Brake Lever from equalizer located underbody. 8. Now disconnect all the parking brake cable clamps from the body mountings. INSTALLATION OF CABLE Carry out the above steps in appropriate sequence for its fitment. NOTE: 1. Fit the cable to the brake shoe lever. 2. Fit the parking brake cable clip to the brake back plate securely. INSTALLATION OF PARKING BRAKE LEVER 1. Proceed in the reverse order of removal. 2. Tighten the mounting bolts of the parking brake lever to the torque specified. 3. Adjust the parking brake cable slackness as per the procedure given. 4. Reconnect the electrical connections to the parking brake switch assembly and confirm that the parking brake lamp becomes “ON” when parking brake lever is at first notch.