TIGOR EV SERVICE MANUAL

DRIVESHAFT 11 11. PRECAUTION TO AVOID THE DAMAGE TO DRIVE SHAFT 1. Avoid damaging the surface of the threads and splines during installation. 2. Clamps should be in position and tight. If clamps are loose, don’t install into vehicle. 3. To prevent damage to the internal components of the inboard joint, take all precautions to avoid over extending the joints. 4. Protect this surface from nicks and scratches. Damage to this surface may reduce the performance of the mating Boot. 5. Protect deflector ring from impacts, which could cause dents. A dented/Damaged deflector ring may result in an interference condition and affect the Boot. 6. Eared clamp must be in position and crimped. Take precaution to avoid any contact between the ear of the clamp and any object 7. Take precaution to avoid any contact between the inboard Boot and the tooling used to insert the assembly into the transmission