NEXON EV SERVICE MANUAL

HV ELECTRICAL SYSTEM 19 A. NORMAL/AC CHARGING Precautions for Normal Charging 1. Proper maintenance of earthling pit is must. Add water & add salts at regular intervals into the earth pits in order to maintain the value of earth resistance. Check annually the condition of the electrodes so as to add or replace electrodes. 2. The electrical socket used for EV charging and its associated wiring should be able to supply 15A dedicated load continuously. 3. Check the charging inlet for accumulation of dust or any foreign objects. 4. Don’t try to pull off the charging gun during charging. 5. Don’t pull out the charging gun if it is in locked condition as excess force can break or damage the locking mechanism. Charging instructions 1. Vehicle must be parked with park brake in engaged state before connecting the charging gun. 2. Vehicle charging port must be free of dust, water or snow while connecting the charging gun; if not proper cleaning method must be used to remove dust, water and ice. Refer ‘Section 6. Cleaning of Vehicle Inlet’. 3. If the charging gun is removed, reinsertion should be done after at least 10 seconds of removal of the charging gun. Gun unlocking feature on EV The charging gun will automatically un- lock once you switch off AC power sup- ply, in Normal Charging. In case of Fast Charging it will take around 15 seconds for the charging gun to unlock. Normal Charging procedure: 1. Engage the park brake. (Charging will not start without engaging the park brake). 2. Connect the plug to the AC power socket. 3. DO NOT plug into a power strip. 4. Open the protective cap on Charging Gun. 5. Pull the ‘Charging-inlet Flap Open Lever’ to open the charging inlet flap. 6. Open the protective cap on Charging Inlet. 7. Before connecting the charging gun to vehicle charging socket, make sure the gun lock is released. CAUTION: If the Gun Lock is not released please don’t insert the Charging Gun forcefully into the socket. It may damage the Charging Socket. 8. If the actuator is engaged and the gun is not getting inserted properly, contact TML service center.