NEXON EV SERVICE MANUAL

LV ELECTRICAL SYSTEM 8 3 INDICATOR LAMP WARNING LAMP AND OTHER LAMPS CONDITION POSSIBLE CAUSE CORRECTION/REFERENCE ITEM Front right / left signal lamps not working 1. Grounding point loose Tighten the grounding properly 2. 10 pole Head Lamp connector at the lamp loose Fix the connector properly 3. Bulb fused Fix the bulb properly. Replace bulb if blown Rear right / left turn signal lamps not working 1. Grounding point loose Tighten grounding properly 2. 8 pole Rear Lamp Connector loose Fix the connector properly 3. Bulb fused Fix the bulb properly. Replace bulb if blown Both Turn Indicators not working 1. Flasher fuse (10A) in cabin fuse box loose/blown(BASE & MID) Fix fuse properly in the base. Replace fuse if blown 2. Flasher in cabin fuse box faulty(BASE & MID) Replace Flasher 3. No output from BCM (HIGH) Refer BCM Diagnosis Side repeater lamps not working 1. Connectors (2 pole) at the lamps loose Connect the connectors properly 2. Bulb loose/ blown Fix the bulb properly. Replace bulb if blown 3. Grounding point no. Tighten grounding properly 4. No output from BCM (HIGH) Refer BCM Diagnosis Indicator lamps not working when hazard warning switch is operated 1. 8 pole connector at the front fascia panel switch loose Fix the connector terminal properly 2. Hazard warning switch faulty Replace switch 3. No output from BCM Refer BCM diagnosis Reverse lamp not working 1. Grounding point no. E00 loose Tighten grounding properly 2. Bulb fused Replace bulb if blown 3. 8 pole tail lamp connector loose. Fix the connector properly Stop (Brake) lamps not working 1. 8 pole tail lamp connector loose Tighten the connector properly 2. Bulbs fused Fix the bulbs properly. Replace bulbs if blown 3. Brake lamp switch faulty Replace switch Stop Lamps are controlled by BCM. If issue not resolved by above methods, BCM diagnosis should be referred. Stop(Brake) Lamp and High Mounted Stop Lamp not working 1. Stop Lamp and High Mounted Stop lamp 10A. Fuse in Cabin Fuse Box Blown Replace Fuse