ALTROZ SERVICE MANUAL

TRANSAXLE - TA5260 32 22. Remove Oil Feeder Lay shaft. 23. Remove input shaft cylindrical bearing from Front housing using bearing race Puller 5438 5890 2618 . PROCEDURE FOR REMOVAL OF INPUT SHAFT BEARING  Position the transaxle RH side case, facing the bearing in upward direction.  Take the bearing puller (5438 5809 2618) and place the outer hub of puller on the machined surface of transaxle casing, surrounding of the input shaft bearing.  Rotate the pulling nut 30 mm anticlockwise and allow anchoring body shaft of puller to get inserted inside the bearing.  Once the anchoring body is inserted fully, hold the locking stud on the top using open end spanner 8 mm and turn the locking nut on the top slowly using open end spanner 17 mm, few turns till it gets resistance to rotate.  It allows flaring the anchoring body and gets lock with bearing rollers. CAUTION: Please stop once the shaft is locked, excess rotation of locking nut may cause damage to puller of bearing.  Once the anchoring body is locked with bearing hold the anchoring body shaft at the top using the open end spanner 18 mm.