ALTROZ SERVICE MANUAL

CLUTCH_PETROL 18 5. Insert the Clutch Cable stud in the clutch release lever & Pin, then tighten the nut till clutch pedal achieves height in line with brake pedal. To ensure clutch pedal height setting properly, follow below instructions. 6. After setting clutch pedal in line with brake pedal, pump the clutch pedal for 10 to 15 times, after that start engine & run vehicle for 2 to 3 Kms with clutch pedal actuations like city cycles traffic bumper to bumper, check clutch pedal height & if required set it. C. REMOVAL OF CLUTCH: 1. Position and Lift the car using two post lift. 2. Disconnect battery and electrical connections of the starter motor. 3. Loosen mounting bolts and remove starter motor. Disconnect and remove transaxle along with clutch housing from engine (for procedure refer transaxle group). 4. Loosen the clutch release lever bolt & nut & remove the lever. 5. Remove clutch release bearing with sleeve 6. Support clutch pressure plate and clutch disc with mandrel & remove. NOTE: 1. It is recommended to replace a defective disc having any of the above mentioned defects with a new genuine clutch disc. We do not recommend removal and replacing of clutch facing. 2. We do not recommend overhauling of the clutch pressure plate assembly. However, before re- fitment, the assembly should be checked for specifications and should conform to the data of clutch pressure plate assembly given on page 3. 3. Use correct clutch discs for the 1.2L NG NA versions Identification. 4. Use Disc and Pressure plate of the same make. Ensure that the clutch facing material is not contaminated with oil or grease as this shall result in clutch slipping. INSTALLATION OF CLUTCH: Carryout the clutch removal steps in appropriate sequence for its fitment. However, following care must be taken during installation. Clean friction face of flywheel and check for cracks, scoring, burn marks or unevenness. If necessary, machine flywheel friction face just to clear the defect. Lightly apply Dow corning P40 grease on the disc splines. Install disc and pressure plate assembly. Press the aligning mandrel through the pressure plate assembly and clutch disc and centralize clutch disc on flywheel by locating the mandrel at the flywheel end.