ALTROZ SERVICE MANUAL

CLUTCH_DIESEL 21 NOTE: Do not mix clutch mounting bolts with other fasteners. Do not use longer or shorter screws. Longer screws may not tighten the clutch at all. Shorter screws will not provide enough threads to achieve desired tightening.  While tightening the clutch mounting screws check aligning mandrel for continuous free sliding to ensure concentric installation of clutch disc which will avoid trouble during the installation of the transaxle. E. CLUTCH MASTER CYLINDER REMOVAL 1. Disconnect the battery connections. 2. Remove the splash guard and drain the clutch fluid from the hydraulic adapter. (For procedure refer clutch fluid draining procedure in this section.) 3. Pull out the clip using a screw driver and disconnect the high pressure line from clutch master cylinder by pulling it out. NOTE After disconnecting the high pressure line, plug the CMC opening with suitable cap to avoid entry of any contaminants. 4. Disconnect the hose connecting clutch master cylinder by removing the clamp. NOTE: Collect the fluid from the fluid reservoir in a clean container. OR Ensure that fluid does not fall from the hose.