ALTROZ SERVICE MANUAL

ELECTRICAL 52 14.3 COMBI STALK REPLACEMENT PROCEDURE 1. Remove the combi switch from vehicle. Refer removal & refitment of steering nacelle from steering section. 2. Disconnect combi switch connection. 3. Remove the two mounting screw of the stalks as shown below 4. As shown, Two screws are dismantled to remove light stalk. Same two screws on wiper side to be removed to dismantle wiper stalk 5. Remove the stalk. INSTALLATION: 1. Fit the new stalk. 2. Tight the mounting screws of stalk. 3. Fit the combi switch. Torque value Table Component Tightening torque value Light / Wiper Stalk tightening torque in Daesung make Combi Switch 0.3 to 0.4 Nm Light / Wiper Stalk tightening torque in MRPL make Combi Switch 6 to 8 kgf-cm Clock Spring 1.2Nm 14.4 PINOUT DETAILS: a) Light Stalk connector