TIAGO TIGOR BSVI - SERVICE MANUAL

ELECTRICAL 125 KEY BATTERY REPLACEMENT FOR FLIP KEY Remote control key contains a battery, which is housed under the cover. If red LED on remote flashes for 5 times after operating any button on remote. lt is recommended to replace battery at a TATA MOTORS Authorized Service Centre. You should, however, proceed as follows if you wish to replace the discharged battery yourself: 1. Open the key blade. 2. Press off the battery cover with your thumb or using a flat screwdriver at the points of the arrows. 3. Remove the discharged battery from the key by pressing the battery downwards at the point of the arrow. 4. Insert the new battery. 5. Ensure that the “+" symbol on the battery is facing upwards. The correct polarity is shown on the battery cover. 6. Position the battery cover on the key and press on it until it is heard to lock in place. NOTE • • Use CR 2032 battery only. • • An inappropriately disposed battery can be harmful to the environment and human health. Dispose the battery according to your local law(s) and regulation. LEARNING OF THE RKE (REMOTE KEY) Learn the RKE (remote key) as per below mentioned procedure a. Unlock the vehicle and open the driver door. b. Turn ON->OFF->ON Ignition 6 times within 6 seconds and observe flasher feedback. Two flashes of Left - Right indicator Lamps and Telltale outputs that indicates BCM entered into Remote key learn mode. c. During 10 seconds time period, press both Lock and Unlock buttons of Remote Key simultaneously. d. BCM shall flash Left - Right indicator lamp and Telltale twice. In parallel, doors get locked and unlocked. e. Learn next Remote Key as per steps c and d, if required. Note: Maximum four keys can be learned. f. On exiting learning mode, BCM shall give single long flash.