ALTROZ SERVICE MANUAL

SUSPENSION 36 9.10 ON VEHICLE REAR SHOCK ABSORBER AND COIL SPRING REMOVAL AND ASSEMBLY REMOVAL 1. Lift the car using two-post lift. 2. Remove Rear Wheel. 3. Position the hydraulic jack below the coil spring pad of torsion beam in such a way that it slightly compresses the spring. 4. Loosen rear Shock Absorber bottom fastener. 5. Similarly carry out the above steps for the other side. 6. Remove both the shock absorber fasteners holding the torsion beam using hydraulic jack at any one side. NOTE:- Bolt to be tighten in pre-loading condition. 7. Now slowly release and hold the hydraulic jack pressure so that both the coil springs along with top rubber can be pulled out. CAUTION: Do not lower the torsion beam below certain level as the brake hoses will be damaged. 8. Remove Rear Shock Absorber top mounting nyloc nut fastener inside luggage compartment. 9. Remove Rear Shock Absorber. ASSEMBLY Follow the reverse procedure of removal of shock absorber assembly.