ALTROZ SERVICE MANUAL

DRIVESHAFT_PETROL 11 5. Protect deflector ring from impacts, which could cause dents. A dented/Damaged deflector ring may result in an interference condition and affect the seal. 6. Eared clamp must be in position and crimped. Take precaution to avoid any contact between the ear of the clamp and any object 7. Take precaution to avoid any contact between the inboard seal and the tooling used to insert the assembly into the transmission 13. DISASSEMBLY PROCEDURE FOR (TRIPOT JOINT) 1. Hold the centre of the axle shaft in the vice as shown in below Fig. and clean the shaft thoroughly, using cleaning solvent. Important: Do not damage the sealing surface of outer housing. 2. Remove the small seal retaining clamp from the axle shaft with a side cutter or by tapping the clamp ear junction screw driver with rounded edge as marked in below figure. Discard the small retaining clamp. Important: The screw driver should not damage the seal. 3. Remove the larger retaining clamp from the inboard joint by using the screw driver/plier.