ALTROZ SERVICE MANUAL

1.2L REVOTRON ENGINE 100 38. Remove support brackets. 39. Safely lift the engine with the help of crane and fix it on repair stand 5425 5890 0605. 40. Fix the LH & RH mounting brackets & adaptor for engine mounting LH bracket to the engine. SPECIAL TOOL  LH Mounting Bracket -: 5424 5890 24 03  RH Mounting Bracket -: 5424 5890 24 02  Adaptor for engine mounting bracket LH 5438 5890 24 03  Engine Installation : 1. Engine installation is generally reverse of removal. Make certain all hardware is tightened to appropriate torque specification. 2. Prior to installing the engine, inspect the condition of the rubber on the engine mounts. Replace the engine mounts if the rubber is damaged. 3. Mount the transaxle back onto the engine. Tighten the bolts with specified torque. 4. Install the starter motor and engine wiring harness along with its mounting brackets. 5. With the vehicle raised on the vehicle lift hoist, place the engine underneath the vehicle, aligned with the engine compartment. CAUTION  Use care when lowering the vehicle body to the engine and transaxle assembly. Verify all the engine and other components will not make direct contact or vehicle damage will occur. 6. Slowly and carefully raise engine into engine bay. 7. Connect the lifting crane to the engine with a chain / belt. Raise the hoist slightly to apply lifting tension to the engine. 8. Secure the engine in the vehicle by attaching the "C", "A" and "B" mounting brackets. Tighten the mounting bracket hardware at specified torque. NOTE  While tightening of B mount, use 12 mm 3 no’s of sockets on consecutive 3 mounting bolts as shown in fig. 9. With the engine attached to the crane, remove the support stand. 10. Remove the chain / belt after engine mounts are secure. 11. Install the left and right driveshaft assemblies. 12. Connect the gearshift linkage, clutch cable to the engine and transaxle.