HARRIER_SAFARI FESTIVE EDITION

HARRIER_SAFARI FESTIVE EDITION 24 E. STEP 2: CHECKING THE TIRE PRES-SURE 15.Stop the vehicle after driving about 3-10 km (2-6 miles).Check and, where necessary, adjust the pressure of the damaged tire. Remove the protective cap from the end of the hose. Screw the hose firmly onto the valve of the damaged tire. 16.Read the tire pressure from the pressure gauge. If the pressure of the sealant-filled tire is 130kPa (1.3 bar, 19 psi) or more, it must now be adjusted to the pressure specified for your vehicle (Refer sticker on vehicle). WARNING If the tire check shows that the pressure of the sealant-filled tire is less than 130kPa (1.3 bar, 19 psi) or if there are any visible cracks, bumps or similar tire damage on the side wall, you must not continue to use that tire.  Make sure that the compressor switch is switched off to “0”.  Insert the power plug into the 12volt power socket connection.  Start the motor (only if the vehicle is outdoors or in a well ventilated area). 17.& 18. Switch the compressor on to “I” and pump the tire up to the specified tire pressure within max. 10 minutes. NOTE Compressor unit we can use for filling the air & checking the pressure of the normal tire.  Switch the compressor off and check the tire pressure again. If tire pressure is too high, deflate the tire to the specified pressure using the pressure “air release” valve.  Rest of the remaining sealant in the hose might leak out when opening pressure “air release” valve or taking off the protective cap of the hose. Please use protective glove for safety purpose.  Once you have inflated the tire to its correct tire pressure, switch off the compressor, pull the plug out of the socket, unscrew the hose, fasten the tire valve cap and put back on the protective cap of the hose.  Leave the bottle in the holder and store the Puncture repair Kit away safely in the vehicle trunk. WARNING After using the sealant you may drive no faster than 80 km/h (50 mph), and the damaged tire must be replaced as quickly as possible (within a maximum driving distance of 200 km (120 miles). You must not continue to drive if heavy vibrations, unsteady steering behaviour or noises should occur while driving. 19.& 20. Drive to the nearest workshop to get the damaged tire repaired and if the tire repair is not possible, tire should be removed from the car. Before the tire is removed from the rim, inform your tire dealer that the tire contains seal-ant. Sealant deposits in a used hose may impair proper function of the Puncture repair Kit. Both the sealant bottle and the hose need to be replaced together after using the Puncture repair Kit. NOTE Remember that emergency road-side tire repair kits only provide temporary mobility. Regulation concerning tire repair after usage of Puncture Repair Kit may differ from country to country. You should consult a tire specialist for advice. WARNING Before driving, ensure tire is adjusted to recommended inflation pressure as indicated on vehicle placard. Monitor tire pressure until sealed tire is replaced. Proceed as described above from point 15 on-wards. New sealant and replacement parts can be purchased from your authorized repair shop or dealer. Sealant bottles can be disposed with household waste.