TIAGO PREMIUM

TIAGO_TIGOR PREMIUM 46 OAT SENSOR REMOVAL 1. Remove the Front bumper. (For removal, refer Font Bumper removal procedure in Body Section). 2. Disconnect the electrical connection. 3. Pull out the OAT sensor from the location. FITMENT For fitment follow reverse procedure of removal. INSPECTION Measure the resistance between terminals of the sensor at minimum two temperatures. The resistance value should match with stated values of resistance in table below T (˚C) R Gerber (Ω) Tol (K) U (V) -10 16567.3 ± 277.6 ± 0.30 2.5261 ± 0.0347 0 9773.2 ± 118.4 ± 0.25 2.2035 ± 0.0310 +10 5953.9 ± 102.8 ± 0.36 18366 ± 0.0327 +20 3737.3 ± 79.0 ± 0.50 14661 ± 0.0323 +30 2412.0 ± 57.6 ± 0.60 11297 ± 0.0295 3. THERMISTOR OR THERMO SENSOR It is a temperature-sensing device, which is positioned at the coldest point of the evaporator (as shown in the fig below) . The control unit switches OFF the compressor at a temperature when condensed water tends to form ice on the fins of evaporator. Thus it maintains the evaporator temperature within a specified range. LOCATION It is mounted on Air intake / Evaporator housing assembly PIN OUT