HARRIER and SAFARI IFD

5412 5460 00 09 NOTE 1. LAY THE WIRING HARNESS AS PER THE LAYOUT SHOWN & SHOULD START FROM DATUM POINT. 2. ENSURE THAT WIRE/CABLE ARE NOT PINCHED WITH THE TRIM OR ANY OTHER COMPONENTS. 3. FOR CONNECTOR NUMBER AND OTHER DETAILS REFER TO THE WIRING HARNESS DRAWING NUMBER 5412 5460 0408. 4. WHEN MATING CONNECTOR, LISTEN FOR THE CLICK TO ENSURE THEY ARE CONNECTED PROPERLY. ENSURE MATED CONNECTORS ARE LOCATED IN THE PANELS TO PREVENT RATTLES. 5. ALL CLIPS SHOULD BE FITTED INTO THE PANEL. EDGE CLIPS SHOULD BE FITTED SO THEY ARE FULLY LATCHED ON THE PANEL. IF A CLIP IS FITTED INTO THE WRONG HOLE THE CLIP MUST BE REPLACED WITH A NEW CLIP. 6. ENSURE THE CORRECT FIXING ARE USED AND TORQUE TO THE SETTING AS LISTED IN THE DRAWING. 7. ENSURE THE HARNESS IS NOT TWISTED DURING INSTALLATION. 8. ANTI-RATTLE BAGS(IF FITTED) SHOULD BE PULLED OVER MATED CONNECTOR TO STOP RATTLES. 9. CLIP ON THE HARNESS SHOULD BE FITTED TO THE VEHICLE IN THE ORDER SHOWN ON THE INSTALLATION DRAWING. 10. DURING THE INSTALLATION IF THE HARNESS IS DAMAGED IN ANY WAY IT SHOULD NOT BE FITTED AND CHECKED BY QUALITY BEFORE USE. 11. ENSURE ALL COVERS AND BOOTS ARE FITTED SECURELY AFTER THE CONNECTOR OR TERMINAL. 12. ALL GROMMETS SHOULD BE INSTALLED SO THAT THE SEAL IS FITTED AS PER DRAWING. 13. FOR CAD REFERENCE, PLEASE REFER 5412 546D 0008 CHECK POINT FOR EARTHING. 1. ENSURE THAT “PAINT MASKING BOLTS” ARE APPLIED BEFORE PAINTING PROCESS AT LOCATION “EAXX” 2. REMOVE THE “PAINT MASKING BOLTS” BEFORE ASSEMBLY. 3. VISUALLY CHECK “WED NUTS” ARE FREE FROM PAINT AT EARTHING LOCATION “EAXX” 4. TIGHTEN THE EARTHING BOLTS AS PER SPECIFIED TORQUE TABLE (TS12805). 5. USE LOW TEMP. GREASE IN ALL EARTHING AREA, PART NO. 5514 0863 342. 6. APPLY GREASE IMMEDIATELY AFTER MASKING BOLT REMOVAL(BEFORE EARTHING).