TATA PUNCH-SERVICE MANUAL

ELECTRICAL 42 10 SUSPENSION ECIE / PRE-LOADING CONDITION NOTE Vehicle Images are only for illustrative purpose actual vehicle may be different for ECIE / Preloading condition. 1. After working on any of the following fasteners, do not apply complete torque. Just do the partial or hand tightening. Ensure that no clamping torque applied. a) LCA front bush fastener b) RTB Pivot mounting fasteners c) Rear Shock absorber bottom mounting fastener. 2. Park vehicle on pit. Image for Illustration only 3. Load the vehicle with two persons in front and one in rear such that one person on driver and co-driver seat each and one person on rear seat in center of seat. The weight of the person seating should be between 70Kg to 80Kg. NOTE:- Loosen the fasteners partially ensuring that no clamping torque applied and bolt is not disengaged from nut. 4. Rumble the vehicle suitably Image for Illustration only 5. Tighten the bolt with the specified torque. Anti-roll bar link mounting on Sub-frame Lower link front pivot mounting (Lower Control Arm) Torsion beam to shock absorber Pivot bush bolt 6. It is to be ensure that vehicle is kept loaded as per point no. 3 while performing activity no. 4 to no. 6. 7. Unladen the vehicle. NOTE:- This procedure should be follow for any of above- mention fastener under consideration of working.