TATA PUNCH-SERVICE MANUAL

AMT KIT 21 D. DC MOTOR REMOVAL AND RE-FITMENT: Removal  Remove Oil tank (Refer oil tank removal procedure).  Disconnect the connector of the wiring harness from the ‘DC Motor’.  Unscrew the three fixing screws M5x15.  Remove the electric ‘DC Motor’, the ‘Sponge’ and the ‘Oldham Joint’. INSTALLATION:  Insert the ‘Oldham Joint’ in the pump shaft. Using a screw driver, turn the joint as shown below, to align its slot with the axis passing through the two fixing threaded holes at 180° on the ‘Power Unit Base Plate’ body.  Turn the ‘Dc Motor’ shaft by hand as shown below, to align it with the axe Passing through the two fixing hole at 180°.