TATA PUNCH-SERVICE MANUAL

TA65 Star AMT 26 9. Remove mounting on Lower Control Arm (LCA) & pull out Lower control arm from Knuckle. 10. Drain the Transaxle oil from Drain plug as shown below 11. Swing out both drive shafts from transaxle and place it suitably alongside. Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 12. Disconnect Transmission earthing cable from Gear Box. 13. Lower the car & support the Engine from Bottom side. 14. Remove B-Mount Nut & Loosen B Mounting stud as shown 15. Remove starter motor mounting Bolt. 16. Remove Gear Box Housing mounting bolts on Engine from top side. 17. Uplift the car on post & give support to Engine using lifting Device. 18. Remove Housing mounting bolts on Engine from Bottom side. 19. Remove Electrical connection of Speed Sensor & to AMT Kit.