TATA PUNCH-SERVICE MANUAL

DRIVESHAFT_PETROL 13 ASSEMBLY PROCEDURE: 1. Install the new small seal retaining clamp on the neck of the seal. Do not crimp the small seal retaining clamp. Slide the tripot seal into the axle shaft, passing over the seal grooves of the axle shaft towards the CV end of the axle. 2. Place the tripot spider assembly on to the drive axle shaft. Assemble the spider assembly to the axle shaft and tap gently if required. Insert the new circlip ring using the plier Important: Ensure that the ring is fully seated in the groove on the axle. 3. Transfer approximately half of the grease from the service kit into the seal and half grease into the tripot housing. Slide the housing over the spider assembly on the shaft. Engage the tripot seal with the tripot outer. Important: The end of the tripot seal must be next to the seal stop on the housing. 4. Slide the tripot seal smaller end to the corresponding groove on the axle shaft and crimp the small seal retaining clamp (new one) using pincer crimping tool) and maintain max 2.6 mm. ear gap as shown below. (Spider Assembly at approximately middle of the tripot bowl). 5. Slide the new large seal retaining clamp over the housing in the free condition of the boot and housing Insert the swage tool part no: 2779 5890 2001 over the clamp.