TATA PUNCH-SERVICE MANUAL

1.2L REVOTRON ENGINE 123 7. Remove the Intake valve and exhaust valve from cylinder head. SPECIAL TOOL  Valve Spring Compression Support Rail - 5424 5890 06 06 NOTE  When removing the valves, valve springs and retaining components, note the location of each and keep these components together so the valves, springs and retaining components are installed in the same location in the cylinder head during reassembly. SPECIAL TOOL  Valve Spring Compression Tool - 2829 5890 06 05 8. Move the valve spring compressor rail to the exhaust side of the cylinder head. 9. Repeat the procedure for exhaust port, noting the locations and components for each valve for proper reassembly. IX. Removal of Cylinder Block Sub- Assemblies 1. Lock the balancer shaft in the bedplate using a locking bolt (5715 0310 9904) as shown below. 2. Remove the two mounting counter sunk screw and take out the thrust washer. 3. Remove the Balancer Mass with locating pin in balancer shaft by removing the mounting bolt.