TIGOR EV

STEERING_BOSCH 18 3.3.4. OBJ ON-VEHICLE REMOVAL NOTE RAP need not be removed; to remove OBJ on vehicle disconnect the OBJ at Steering Knuckle. 3.3.5. DO’S & DON’TS DON’TS 1. Never lift steering gear by holding bellows. 2. Never store steering gear resting on its bellows. 3. Never store / transport steering gear with bellows fouling with other objects. 4. Never remove port plug before connecting with mating parts. 5. Never use cotton waste which will cause contamination. 6. Do not adjust ball joint nuts except during wheel alignment 7. Never lift steering gear by holding tie rod. 8. Do not remove the protective cap from the pinion shaft during transit or before assy. 9. Do not remove the protective cap from the OBJ during transit or before assy. NOTE Bellow is a seal. Do not use sharp tools near bellows if it can damage bellows. ! CAUTION Damaged bellow or absence of clip can cause water ingress and subsequent failure of Power steering. DO’S 1. Lift steering gear by holding mountings / body / cylinder only. 2. Store / transport steering gear resting on body / cylinder only. 3. Use steering gears on ‘first in first out’ basis. 4. If any steering gear is dropped, inspect for damage before using. 5. If any bellow is found damaged, replace it immediately with a good part & with proper position of clips 6. If any bellow clip is found missing, do not use the defective steering gear. Instead use another new steering gear 7. If the steering gear is off the vehicle, all ports should be covered with protective plugs to avoid contamination.