TIGOR EV

DRIVESHAFT 6 7. ON VEHICLE REMOVAL OF DRIVE SHAFT (LH & RH SIDE) 1. Remove Wheel Cap. 2. Loosen Front wheel nuts. 3. Lift the vehicle 4. Remove Front Wheels. 5. Remove Mud Liner. 6. Apply Brake and Remove Drive shaft Lock Nut. 7. Use Allen key and disconnect upper ARB link from Front strut. 8. Remove ball joint (steering rack) mounting from steering knuckle from RH & LH. 9. Remove ball joint (steering rack) from steering knuckle from RH & LH sides using tool part no. 2702 5890 4602 10. Remove stub axle ball joint Mtg. & pull out Lower Control Arm (LCA) from knuckle. 11. Pull out Knuckle End and take out RH Drive shaft from Knuckle End. 12. Swing out drive shafts from transaxle and place it suitably alongside. Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot.