TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 72 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Trouble Shooting:- Step Checks IF YES IF NO 1. Check the bypass valve Connector for any damage Replace connector Go to step 2 2. Is there any dirt or Rust on Connector Remove the connector and clean it and refit it tightly Go to Step 3 3 Perform the bypass valve actuator test. Is the test successful Go to step 4 Some problem in Wiring harness connections 4. Check the continuity between the EMS ECU pin 149 and connector pin 2. Check the continuity between the bypass valve connector pin 1 and EMS main relay supply. Is continuity test successful Go to step 5 Establish continuity by rectifying wiring harness connections as per the schematic. 5. Is the by pass connector pin 1 short Circuited to battery/Ground. Perform this test by keeping Ignition Off. Go to Step 6 Rectify Wiring Harness connections as per the schematic 6. Check whether the bypass valve control pin 149 is Short Circuited to battery Rectify Wiring Harness connections as per the schematic Go to step 7 7. Is the resistance across the bypass valve terminals less than X ohms? Go to Step 8 Replace the By pass valve 8 Check whether any bypass pins are backed out at ECU Connector or by pass valve connector Rectify the connections Go to Step 9 9 Is there any physical damage to bypass valve connector / ECU Connector Replace the respective connectors Go to step 10 10 If the fault still persists Replace the EMS ECU Repeat the above procedure for reconfirmation DTC’s confirmation:- After rectification, ensure the following points by referring engine parameters using TML diagnostic tool before handing over to customer. Perform the actuator test for bypass valve. Test result should be successful.