TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

Prepared by: Airbag COC Review Approved by: Sanjeev VM Page: 535 of 648 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. SRS / Airbag ECU AB12 DTC Troubleshooting Guide Version: 2.0 Date: 21-June-2021 B0070-1A:- Driver retractor Pretensioner Deployment Control circuit resistance below threshold Overview:- ISO Code B0070-1A Customer Symptom SRS Warning Lamp continuously ON in Instrument Cluster. Fault Effects (On Vehicle) Driver retractor Pretensioner deployment not guaranteed, if a crash happens Lamp Status (If Any) SRS Warning Lamp continuously ON in Instrument Cluster. Fault Detection Condition This fault gets logged if the circuit resistance of Driver Retractor Pretensioner circuit resistance is below the threshold value (1.4 Ohm) after 3 seconds of cranking. Normal Operating Condition The minimum threshold is 1.4 Ohm. Probable Trouble Area Related wiring Harness, connector or terminals Driver retractor Pretensioner Module Airbag Wiring Harness Airbag ECU Healing Condition Minimum threshold resistance should be 1.4 Ohm. Component Details:- (Refer Annexure 2 for Mounting Location of AB12 Airbag ECU) Seatbelt Pre-tensioners :- Seatbelt Pre-tensioners retracts forcefully to adjust occupants into a safer seating position when the airbags deploy. It is usually located in the B-pillar and is connected with the seat belt buckle assembly. Airbag ECU : - It is fitted in the floor of central console in the car. The Airbag Electronic Control Unit (ECU) controls the deployment system to allow an appropriate igniting of the Airbags and belt pre-tensioners to restrain the driver and passengers Preliminary Checks:- 1. Check Battery Voltage (12 V & above) 2. Check for any faults in Airbag Warning Lamp indication in Instrument Cluster. 3. Ensure the proper locking of Airbag ECU wiring harness connectors in the vehicle by the locking sound. Troubleshooting:-