TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 281 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P0202-13: Injector 2 Open Circuit– Circuit Open Overview: ISO Code P0202-13 Customer Symptom Vehicle Acceleration poor, Idle not stable, Poor Startability, Engine might Stall. Fault Effects (On Vehicle) Engine might Stall, Vehicle Acceleration poor, Idle not stable, Poor Start ability, LAMBDA Control deactivated. Lamp Status (If Any) MIL ON after 1 drive cycle Fault Detection Condition This fault gets logged if the ignition state is ON and Injector of cylinder 2 control pin is Open Circuited Normal Operating Condition Proper Wiring Harness connections between Injector of cylinder 2 and EMS ECU. Probable Trouble Area Wiring Harness Connections Healing Condition Ignition ON and 3 driving Cycles Fault permanent deletion 1. Clear DTC Command form Scan tool 2. Stack Over Flow. 3. 40 warm up cycles. 4.ECU flashing 5. ECU Power-Fail Component Details: Injectors are normally closed valve. Injector Opens when its electromagnetic coil is energized by the EMS ECU. Preliminary Checks: 1) Loose/ Damaged Connections between injector and EMS ECU. 2) Check for back out of pins at both Injector connector and ECU connector. 3) Check for damage of pins at both injector connector and ECU connector. 4) Check the continuity from injector connector pins to the ECU pins.