TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

Vehicle Platform: Zest, Bolt, Tiago, Tigor, Osprey, Q501, X451, Q502 ECU Name: Hella Body Control Module (BCM) DTC Troubleshooting Data Version: 3.1 Date: 30-11-2019 Author: BCM COC Page: 703 of 1106 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. B2213 - 97: Front Wiper Park Position Signal - Component or system operation obstructed or blocked ISO Code B2213 - 97 Customer Symptom Front and rear wash/wipe may not function correctly Fault Effects (On Vehicle) Front and rear wash/wipe may not function correctly Lamp Status (If Any) NA Fault Detection Condition This fault will be logged when user operates the front wiper motor with front wiper is out of park for more than preconfigured delay time due to failure in park input. If out of park fault is detected for front wiper park position signal for more than defined delay then this DTC code will be returned with the results. Normal Operating Condition There should not be any fault returned by routine Probable Trouble Area 1. BCM connector FaultC 2. Cockpit harness Short to battery or open circuit 3. BCM ECU fault Healing Condition 1. Ignition OFF  ON 2. Clear DTC Command Component Details: Front wiper Park Position Signal part of front wiper motor and interfaced to the BCM as a feedback input. If the IGN is on and if user put the combi switch to front wiper on position, front wiper park position signal gives a feedback to BCM about the in park and out of park of the front wiper. Preliminary Checks: Check Battery Voltage (12.5 V & above) Check ECU pins for oxidation, bending & damage. Trouble Shooting:-