TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

Vehicle Platform: Zest, Bolt, Tiago, Tigor, Osprey, Q501, X451, Q502 ECU Name: Hella Body Control Module (BCM) DTC Troubleshooting Data Version: 3.1 Date: 30-11-2019 Author: BCM COC Page: 391 of 1106 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. START Connect Diagnostic tool and Run Input Test Routine and operate the switches as mentioned in the input switch test routine specification. Is DTC B1301 – 12 logged by Routine? Disconnect vehicle battery connection. (Please follow the safety guidelines) Check BCM and Driver door switch connectors for terminal backout Are connectors loose? 1.Remove BCM Connector. 2.Perform visual check of connectors for pins bent or damaged. Is connector faulty? Check continuity between BCMconnector pin [ C1- 1 ] Harness side) with battery [C3-2/C3-1] Continuity Found? 1. Remove Driver door switch 2. Check continuity between BCMharness side connector pin[ C1- 1 ] and Driver door switch [C101-1] STOP YES NO YES NO Reconnect connectors firmly Correct connector fault (Terminals Bend) YES NO Correct BCM Sidewiring harness (Short to Battery) NO YES B1301 - 12: Driver Door Ajar Switch - Circuit short to Battery Open Circuit? Perform the visual check of connectors for pin bend or damaged Is connector faulty? Check continuity at Driver door switch [C101-1] with ground [C1-34/C1-47] Continuity found? BCM ECU Faulty Correct wiring harness (Open Circuit) YES NO Correct connector fault (Terminal Bend) Correct connector fault at Driver door switch mating connector YES NO YES NO Replace BCM ECU Continuity found? YES NO 1. Switch is faulty 2. Replace Driver Door switch Check continuity between two terminals of Driver door switch