TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 1447 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P2176-0: Throttle Actuator Control System – Idle Position Not Learned-no sub type information Overview: ISO Code P2176-0 Customer Symptom Vehicle will drive with limited throttle response Throttle limp home position Fault Effects (On Vehicle) Vehicle will drive with limited throttle response Throttle limp home position Lamp Status (If Any) MIL ON after 1 drive cycle Fault Detection Condition This fault gets logged if the throttle actuator is stuck closed / Blocked due to initial learning of the throttle idle position not possible. Normal Operating Condition Throttle actuator functions as per design Probable Trouble Area Throttle Actuator Valve Healing Condition After 3 drive cycles Fault permanent deletion 1. Clear DTC Command form Scan tool 2. Stack Over Flow. 3. 40 warm up cycles. 4. ECU Flashing. 5. ECU Power-Fail Component Details: A DC motor drive is used to move the throttle valve over the complete movement range. The DC motor is directly controlled by the ECU of the Gasoline engine. Throttle Valve H-bridge driver of EMS ECU provides bidirectional control with active recirculation and over current detection. Preliminary Checks: 4. Pls. check whether dust/mud/any particle is blocking throttle valve. 5. Pls. check whether the throttle valve is stuck closed 6. Pls. check for any throttle body related faults and rectify those faults by following their rectification procedure.