TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 1219 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P1E0B-29: Error for battery charge LED lamp signal.-Battery charge Lamp Signal error Overview: ISO Code P1E0B-29 Customer Symptom 1. Battery LED lamp not working. 2. IAC (Intelligent Alternator Control) may get affect. Fault Effects (On Vehicle) 1. Battery LED lamp not working. 2. IAC (Intelligent Alternator Control) may get affect. Lamp Status (If Any) Nil Fault Detection Condition Battery charge LED short to battery or ground Normal Operating Condition Alternator Control functioning properly Probable Trouble Area Battery LED Lamp not working Healing Condition After 1 Drive cycles and ignition ON Fault permanent deletion 1. Scan tool Service 14 2. Stack Over Flow. 3. 40 warm up cycles. 4. ECU flashing 5. ECU power fail Component Details: Preliminary Checks: 1) Check Battetry LED connection to IC. 2) Check for back out of pins at both ECU connector & IC connector. 3) Check for damage of pins at both ECU connector and IC connector. 4) Faulty ECU. 5) Faulty IC. Trouble Shooting:- Step Checks IF YES IF NO 1. Check Battetry LED connection to IC. Go to Step 2 Establish continuity by rectifying harness connections as per the circuit schematic 2. Check for back out of pins at both ECU connector & IC connector. Rectify/Replace Connectors Go to step 3 3 Check for damage of pins at both ECU connector and IC connector. Rectify/Replace Connectors Go to Step 4 4 Faulty ECU. ECU Faulty Go to Step 5 5 Fault Still Persists? IC Fautly Follow the steps again for reconfirmation DTC’s Healing Confirmation: - After rectification, ensure the following points by referring engine parameters using TML diagnostic tool before handing over to customer.